Image to STL Online

Troubleshooting the conversion

Convert Image to STL

A troubleshooting page for the conversion: why the relief comes out flat, mirrored, huge or fragile, and the one setting that fixes each case.

  • Most bad prints come from low contrast or the wrong direction, not the mesh
  • 300 px detail roughly quadruples the triangle count over 200 px
  • The flat back is at zero height — do not let the slicer auto-orient it
PNG, JPG, WebP or SVG · up to 15 MB · or drop it here No image loaded

Load an image and the 3D preview shows up here. Drag to rotate, scroll to zoom.

—

Files stay on your device — nothing is uploaded, no account needed.

When the picture converts but the print is wrong

The conversion itself rarely fails: any image becomes a mesh. What fails is the match between the mesh and the thing you wanted to print. These are the five complaints that account for almost all of it, and what to change.

1. The relief is a flat plate

Cause: no tonal range. Every pixel sits in a narrow band of brightness, so every height lands in a narrow band too. Fix: raise contrast before converting, or increase max relief height. If the photo was shot in shade, 4–5 mm of relief rescues more than any detail setting.

2. The model is a negative

Cause: the two directions of the conversion are inverses. Lithophane mode makes dark pixels thick; relief mode makes bright pixels high. Pick the wrong one and the picture turns inside out. Fix: tick invert, or switch mode. No need to convert again from scratch.

3. The file is too big to handle

Cause: detail at 300 px on a large, tall image. Triangles scale with the grid, so a 300×900 grid is nearly half a million faces. Fix: drop detail to 200 px. The printed difference at 100 mm wide is invisible; the file goes from tens of megabytes to a few.

4. Thin parts disappear in the slicer

Cause: features narrower than one extrusion width, typical for hairlines, punctuation and thin outlines. Fix: thicken them in the editor, or print larger. At 100 mm wide each grid cell is about 0.5 mm — a 0.4 mm nozzle needs at least two of those to form a wall.

5. The model will not sit flat

Cause: the mesh is built with a flat back at zero height, so it is flat. If the slicer sees it tilted, the model was rotated by hand. Fix: reload the STL, place the flat side on the bed, and do not use auto-orient on a relief — automatic orientation puts the picture face-down.

The conversion in one paragraph

Each pixel becomes a brightness value, each value becomes a height between your base thickness and your maximum height, and the surface is closed into a watertight solid with a flat back and four walls. Millimetres, binary STL, no repair needed in the slicer.

Limits worth knowing

15 MB per image, 300 px maximum detail, PNG/JPG/JPEG/WebP/SVG input, and one image at a time. No account, no upload, no export fee. For a real 3MF mesh this page is not the tool — see 3MF to STL for why.

Questions

Common questions

Why does my STL look like a negative?

Relief and lithophane invert each other. Switch the mode or tick invert; the mesh is regenerated from the same image.

Can I convert several images at once?

No, one at a time. Convert, download, then load the next image — each run takes about a second in the browser.

Which detail setting should I use?

200 px for photographs, 300 px for line art and fine texture, 120 px while you are experimenting with size and depth.

Do I need to repair the STL?

No. The mesh is a closed solid with consistent winding, which Cura, PrusaSlicer and Bambu Studio all accept without repair.

Does it convert 3MF files?

No. 3MF is a mesh container, not an image; this converter builds a mesh from a picture. The 3MF page explains what to do instead.