PNG is the format this converter likes most
A PNG holds exact colour values with no compression damage, which is precisely what a heightmap wants: one brightness number per pixel, no invented pixels in between. Convert a PNG and the STL you get reflects the picture you see, edge for edge.
Drop a PNG in the panel above and it becomes a printable mesh: relief if you want the picture raised, lithophane if you want it to show when backlit.
Transparency, handled
PNG is the one common format that can carry an alpha channel, and alpha has no meaning in a heightmap. The converter composites your image onto white before reading it, so:
- a logo on a transparent background prints as a raised logo on a flat plate;
- a cut-out subject gets a flat white surround instead of a hole;
- a semi-transparent glow area prints thin rather than disappearing.
If you want transparent areas to disappear entirely, fill them with white in an editor first, or crop to the artwork.
What PNGs from different places need
- Screenshots convert cleanly but usually carry UI chrome. Crop before converting.
- Exported logos are often 4000 px wide with a lot of empty margin. Crop to the mark so the print uses its full width.
- Digital art with smooth gradients prints as a soft relief; the detail setting at 300 px is worth it here.
- Scanned drawings have grey paper. Raise the contrast in an editor first, or the whole background becomes mid-height plastic.
PNG vs the alternatives
PNG is lossless, so it is the right choice for logos, line art, screenshots and anything with flat colour. JPG is smaller but throws away detail in blocks; for photographs the difference is invisible in print. SVG is better still for icons and wordmarks, because it rasterises at whatever detail level you pick — see SVG to STL.
Sizes and limits
Up to 15 MB per PNG, up to 300 px on the detail grid, and any aspect ratio — the converter keeps your proportions and derives the model height from the model width you set. A square PNG at 200 px detail comes out as an STL around 8 MB with roughly 160,000 triangles.
After the conversion
Open the STL in Cura, PrusaSlicer or Bambu Studio. The mesh is watertight and in millimetres, so no repair and no scaling is needed. If you want to check the geometry first, load it into the STL viewer and rotate it.