The photo decides the print
The conversion is the easy part. Whether the result looks like the person you photographed depends on what was in the frame: contrast, separation from the background, and how much of the frame the subject fills.
This page is about choosing and preparing the photo. The converter above does the rest in your browser.
What makes a photo printable
- Contrast over colour. A relief only knows brightness. A dark dog on a dark sofa converts into one flat mass, however good the photo is.
- A clean background. Busy backgrounds become busy plastic. Crop until the subject owns most of the frame.
- Even, directional light. Side lighting gives shape; on-camera flash gives a flat face and a hard shadow.
- Sharp focus on the subject. Motion blur turns into a smear of medium heights that no detail setting can recover.
- Enough size. 1000 px on the long edge is plenty. Upscaling a small photo adds no detail to the mesh.
Preparing the file
- Crop to the head, the pet, the building — whatever the print is about.
- Raise contrast slightly; a levels adjustment that makes the darks darker and the lights lighter is usually enough.
- If the photo is noisy, apply a light denoise. Grain prints as bumpy texture.
- Save as PNG if you edited it, or convert the original JPG directly.
Choosing the print size
A face needs about 25–30 mm of width to read as a face. At 100 mm wide, a head-and-shoulders portrait prints with soft but recognisable detail on a 0.4 mm nozzle; at 60 mm it becomes a silhouette. Full-body shots of a group need 150 mm or more before individuals separate.
For a keepsake, 80–100 mm with a 2 mm base and 3 mm of relief is a solid, unbreakable plaque. For a lithophane, the same photo at 120 mm wide, printed upright in white PLA, looks sharper than a relief because light does the work.
Portrait presets in the tool above
- Width 100 mm, base 1.2 mm, relief 3 mm, detail 200 px.
- Subject against a bright background? Leave mode on relief. The face will stand proud and the background falls to the base.
- Photo too dark overall? Raise the relief height to 4–5 mm and lift the shadows in an editor first.
After conversion
The STL is watertight and in millimetres — drop it into Cura, PrusaSlicer or Bambu Studio, put the flat back on the bed and print. If you want to inspect it first, the STL viewer will show you the triangles. For backlit prints, use the lithophane maker.