JPG files, straight to printable geometry
Nearly every photo on a phone or a camera is a JPG. This converter takes one and hands back an STL: brightness becomes height, the model gets a flat back and four walls, and the slicer sees a closed solid.
No upload, no account. The file is decoded by your browser and converted on your device.
What compression does to a relief
JPEG is lossy. It throws away information in 8×8 blocks, which in a photograph is invisible and in a heightmap is a tiny staircase. Three things follow from that:
- Fine noise becomes texture. Grain in a dark portrait prints as speckle. A light denoise or a slight blur before converting removes it without losing the face.
- Sky and smooth backgrounds get blotchy. Those blocks become visible bumps at 100 mm wide. Raising contrast pushes them down into the base.
- Hard edges smear by a pixel or two. For logos and text, use PNG or SVG instead.
For portraits, pets and landscapes, none of this matters — a printed relief has far less resolution than the JPG anyway.
Getting the crop and contrast right
The converter uses the whole frame, so crop to the subject first. Then check the tonal range: a photo shot in flat light converts into a flat relief, because every pixel lands in a narrow band of heights. A quick contrast or levels adjustment before converting is the single biggest improvement you can make.
Backlit subjects and dark backgrounds are the usual failure — the face becomes thick enough to read, the background goes to the base and the whole thing looks like a silhouette. Lift the shadows, or crop tighter.
Settings that suit photographs
- Width 80–150 mm for a portrait plaque; 60 mm for a keychain.
- Base thickness 1.2 mm, max relief height 3 mm as a starting point.
- Detail 200 px for faces, 300 px if the picture has hair, fur or fabric texture you want.
- Mode relief for a print you look at, lithophane for one you backlight.
File limits
Up to 15 MB and any pixel dimensions. A modern phone photo is 3–8 MB and several thousand pixels wide, which is more than the grid needs; the converter resamples to 120, 200 or 300 px on the long edge.
Next steps
Download the STL, open it in your slicer and print it. To inspect the mesh first, drop it in the STL viewer. If your file is a PNG or an SVG, those have their own pages: PNG to STL, SVG to STL.