Pictures, drawings, clip art
A “picture” covers a lot: a scanned sketch, a cartoon from a friend, a screenshot of a family crest, a line of text in a meme. All of them convert the same way — brightness becomes height — but each kind needs a different amount of preparation, and the print only reads if you get that part right.
Line art and sketches
Black lines on white paper are the hardest case, because the lines are thin and the heightmap gives them exactly one cell of width at the detail grid. At 200 px across a 100 mm print, each cell is 0.5 mm — a pencil line vanishes.
What works instead:
- Convert at 300 px detail, which drops the cell size to 0.33 mm.
- Use 2–3 mm of relief so the lines catch light.
- Or invert the idea: put the drawing on a base and carve the lines in, using the “engrave” direction (invert), which prints more reliably at small scales.
Clip art and flat cartoons
Flat colour illustrations convert beautifully — large shapes, hard edges, few heights. A cartoon character at 100 mm wide with 2 mm of relief looks like a stamped plaque. Avoid drop shadows and gradient fills; they add half-tones that turn into soft slopes.
Screenshots and memes
Screenshot text is readable if it fills the frame; a full chat thread at 100 mm wide is not. Crop to the one line you want and let it own the width. Browser chrome, black letterboxing and status bars all become material — crop them out.
Resolution is not detail
A 6000 px picture does not print better than a 1200 px one. At 200 px on the detail grid the mesh has the same number of triangles either way. What matters is contrast, crop and how large the features are relative to the print.
Settings to start with
- Width 80–120 mm, base 1.2 mm, relief 2–3 mm.
- Detail 300 px for line art, 200 px for photographs and cartoons.
- Mode relief for a plaque, lithophane if you want the picture backlit.
Where these prints fall down
Thin isolated features (a single hairline, a punctuation mark) become fragile columns and often break in the slicer’s preview. If a part of the picture prints as dust, thicken it in an editor or drop the feature on purpose. Everything else — the mesh, the walls, the flat back — is handled for you in the panel above.
Looking for photos rather than drawings? Start at photo to STL. Handing the file to a slicer next? The STL viewer shows you what you are about to print.